KLASS Fan ARIME LIGHT Manuel D'utilisation page 18

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
2
- Select the right down rod depending
on the height of your ceiling.
-
If neither of the down rods fits,
contact your fan distributor.
- Remove the screw and bolt from the
hanger ball.
- Remove the locking pin, the two
screws off the coupler.
- Place the downrod through the
coupler cover and the canopy, and
route the electrical cables through the
downrod.
- Install back the screws and bolt to
the hanger ball, ensure to fasten the
screws.
- Insert the downrod into the coupler,
insert the coupling screws and the pin,
tighten the two screws on the coupler
and close with the cover.
3
- Insert the blade to motor assembly.
Use screws and washers to fit each
blade to motor assembly. Tighten the
screws firmly.
- Repeat step for all blades.
4
Hang the fan motor housing on the
mounting bracket, ensure the ball joint
locating the groove aligns with the
notch on the mounting bracket.
downrod
coupler
Blade
Notch
16
screw
hanger
ball
power cord
canopy
coupler
cover
bolt
locking pin
Screws
Motor assembly
Locating
groove
pin

Publicité

Table des Matières
loading

Table des Matières