Using Cli Commands To Reset The Device - Juniper NETSCREEN-5000 Serie Manuel D'utilisation

Notice that the listing contains aggregate1, an aggregate interface comprised of
ethernet2/1 and ethernet2/2. This aggregate interface runs with a throughput
rate of 2 Gbps. You can now bind the aggregate interface to a zone.
Note:
IP address so that other nodes on the network can reach it.
U CLI C
SING
If you lose the admin password, you can use the following procedure to reset the
NetScreen-5000 Series device to its default settings. This destroys any existing
configurations, but restores access to the device.
Warning: Resetting the NetScreen-5000 Series will delete all existing configuration
settings, and the firewall and VPN services will be rendered inoperative.
To perform this operation, you need to make a console connection, as described in
"Establishing a Terminal Emulator Connection" on page
Note: By default the device recovery feature is enabled. You can disable it by entering the
following CLI command: unset admin device-reset.
1. At the login prompt, type the serial number of the NetScreen-5000 Series device.
2. At the password prompt, type the serial number again.
The following message appears:
!!! Lost Password Reset !!! You have initiated a command to reset the device to
factory defaults, clearing all current configuration, keys and settings. Would you
like to continue? y/[n]
NetScreen-5000 Series
As with most other interfaces, you must assign the aggregate interface an
OMMANDS TO

Using CLI Commands to Reset the Device

R D
ESET THE EVICE
25.
33