Table des Matières
Publicité
1618905_6055airMover.qxp 8/8/19 9:51 AM Page 6
ENGLISH
Warning
!
If too much air is exhausted from a space with Open
Combustion Devices (e.g. furnaces, fireplaces or
water heaters) can cause those devices to back
draft. This can contaminate the space with potential
fatal gases.
General instructions
• This unit should only be used as a recirculating fan.
CAUTION: When exhausting air from a space, always
check Combustion Devices with the fan running to
guarantee the back drafting prevention measures are
working.
• The standard orientations are, horizontal (Fig. 1),
vertical (Fig. 2), and sideways (Fig. 3).
NOTE: Care must be taken, especially in the sideways
orientation, not to block the air intake.
• The units can be stacked during storage or transport to
minimize the required space. Stacking Guides are located
on the top and bottom of each unit.
NOTE: Do not stack more than 4 units high.
• To ensure objects are not sucked against the intake
guard during operation, do not place items in front of the
intake guard.
Cord Storage
Your unit is equipped with a cord wrap and storage area
on the back of the unit. To properly store the power cord:
• Turn off the unit.
• Disconnect any units plugged into the unit.
• Unplug the unit from the wall outlet.
• Snugly wrap the power cord around the cord wrap/feet.
• Secure the end of the power cord to itself using the latch
on the plug of the power cord.
6
(Fig. 4)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Publicité
Table des Matières
