Important Safety Information; Installation Instructions - Westinghouse TLED T8 Guide D'utilisation

INSTALLATION GUIDE
Please read all information before installing the lamps and keep this sheet for future reference.
• These lamps are direct replacement as below:
2ft: For 17W/15W/24T8
3ft: For 25W/21W/36T8
4ft: For 32W/30W/28W/25W/48T8
• Operates on Instant Start, Program Start and Rapid Start T8 electronic Ballast; Compatible with T8 emergency Ballast and dimmable Ballasts.
• Risk of electronic shock - Suitable for damp locations when used in a luminaire rated for damp location use.
• Any modifications to this product will void the warranty.
• This lamp may not be compatible with all ballasts, go to www.westinghouselighting.com for compatibility information.

IMPORTANT SAFETY INFORMATION:

DO NOT INSTALL THIS LAMP IN A PRE-HEAT LUMINAIRE.
THIS LAMP ONLY OPERATES ON ELECTRONIC BALLASTS. IF LAMP DOES NOT LIGHT WHEN THE LUMINAIRE IS ENERGIZED, REMOVE LAMP FROM LUMINAIRE AND
CONTACT LAMP MANUFACTURER OR QUALIFIED ELECTRICIAN.
CAUTION RISK OF FIRE - IF THE LAMP OR LUMINAIRE EXHIBITS UNDESIRABLE OPERATION (BUZZING, FLICKERING, ETC.), IMMEDIATELY TURN OFF POWER, REMOVE
LAMP FROM LUMINAIRE AND CONTACT MANUFACTURER.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
Lamps must be operated within an ambient fixture temperature of -22

INSTALLATION INSTRUCTIONS

STEP 1.
Make Sure Power is OFF
STEP 4A.
label
Insert the Westinghouse LED
replacement lamp.
NOTE: Please insert lamp per
label direction (on lamp back)
to make sure the
light-producing side of the
LED tube is facing downwards.
F and 133
o
STEP 2.
Remove the diffuser, lens
cover or louver (if provided).
Fluorescent lamps to be
replaced with Westinghouse
TLED T8 lamps are shown
above.
STEP 4B.
Then, rotate the lamp 90°
degrees.
Make sure that the pins are
completely seated in the
lamp holders. One LED
lamp for each fluorescent
lamp removed.
3
F to ensure UL compliance.
o
STEP 3A.
Remove the fluorescent lamp.
First, rotate the lamp 90°
degrees.
STEP 5.
Repeat steps 3 and 4 as
needed for additional lamps.
Replace the diffuser, lens
cover or louver (if removed in
step 2).
STEP 3B.
Then, remove the lamp from
the lamp holder.
STEP 6.
Power ON.
ESF-WH-014