ZF Marine ZF 360 Family Manuel page 18

Table des Matières

Publicité

ZF PADOVA
CHECK OIL LEVEL
The oil level check must be done two minutes after turning off the engine. The correct oil level is
between the upper and lower marks on the dipstick (see Fig.1.5).
After the initial filling or after carrying out repairs or changing the oil filter, run the gearbox for about
two minutes. Following this, recheck the oil level two minutes after turning the engine off.
Fig. 1.5
OIL CHANGE
2
3
1
Fig. 2.5
Remove the filler cap [2] and extract the oil level dipstick [3], as shown in the figure.
Drain off the lubricant oil by removing the drain plugs [1], saving the gaskets.
Collect the used oil and observe the binding rules for special waste disposal.
Screw in the plugs [1] to torque 50 Nm, fill with oil through the filler cap and screw in the cap to torque
120 Nm.
Plus d'informations sur : www.dbmoteurs.fr
18

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

32.70.360.5001

Table des Matières