Dream On Me DOM FAMILY 401 Instructions D'assemblage page 4

Step 2
Place the base on the flat surface. Hold
onto the pin lock on the base and insert it
into the base tube until the pin lock clicks
into place. Repeat this process to
assemble the rest of the base so that it
looks like the figure to the right.
Step 3
Insert the 3 frame tubes into each of the 3
bases by holding the pin lock (a) and inserting
them until it clicks into place at "b".
Step 4
Each of the frame tubes has a strap hanging
from it with 3 plastic holders corresponding to
the 3 height adjustments. Fit the plastic holder
of the desired height into the slot of each frame
part.
Repeat this process to attach the other two
straps to the frame.
IMPORTANT! Make sure all three straps are
adjusted to the same height.
If done correctly, the activity center
should look like the image below.
NOTICE!
If it looks like the image below, then the assembly
was not done correctly. In that case, please
contact Dream On Me immediately for further
assistance.
a
b
Plastic
holder
4