Troubleshooting; Care & Maintenance - Gioteck HF-1 Mode D'emploi

troubleshooting

Having trouble with your HF-1 controller? These troubleshooting steps will show you the smoothest path to
resolving your issue. Be sure to perform troubleshooting before having your product serviced.
The HF-1 will not turn on.
• Check to make sure that the batteries or battery pack is fully charged.
• Make sure that the batteries are properly installed.
The LED is flashing even though the rechargeable batteries are fully charged.
• Rechargeable batteries provide a low voltage which triggers the LED to flash.
Even at a low voltage, the batteries will still provide substantial game time.
The HF-1 is switched on but is not recognized by the PS3™.
• Make sure that the HF-1 is paired to the PS3™ (see page 6).
• Press the HOME button (the large arched button on the front) to wake the
controller up from sleep mode and reconnect.
The SixAxis function is not working in my game.
• The HF-1 does not have SixAxis support.
For further assistance please contact our customer support team on our website:
www.gioteck.com
10 | TROUBLESHOOTING
care & maintenance
This product has been designed with the highest concern for safety. However, any electrical device, if used
improperly, has the potential to cause harm. To help ensure risk-free operation please pay attention to the
guidelines below.
storage declaration
Gioteck hereby declares that this controller is in
It is best to store the controller in a
compliance with the essential requirements and other
dry and dust free area. Do not store
provisions of Directive 1999/E/EC. To view the full
in areas of extreme heat or cold,
version of the Declaration of Conformity please go
and avoid direct sunlight or heat
online to doc.gioteck.com.
sources such as a heater.
This device complies with Part 15 of the FCC Rules.
Never attempt to open
Operation is subject to the following two conditions:
the controller; doing so will
(1) this device may not cause harmful interference, and
void your warranty.
(2) this device must accept any interference received,
including interference that may cause undesired
environment
operation. The device and its antenna must not be
Please help to conserve the co-located or operating in conjunction with any other
environment by recycling the antenna or transmitter. Gioteck are not responsible
inner cardboard packaging for any interference caused by unauthorized changes
02
of this product. to this equipment.
This controller should NOT This equipment generates, uses, and can radiate radio
be disposed of in normal frequency energy and, if not installed correctly, may
household waste. It should be cause harmful interference to radio communications.
If this equipment does cause harmful interference to
disposed of separately. Please
take it to an electrical waste radio/television reception try the following:
collection point. • Reorient or relocate the receiving antenna.
• Increase distance between the equipment & receiver.
• Connect the equipment into an outlet on a circuit
different from the receiver.
• Consult the dealer or a radio/TV technician.
01
CARE & MAINTENANCE | 11