Worx WA0163 Mode D'emploi page 8

lines or where the branch being cut can
come into contact with overhead power
lines.
cuTTiNg WiTh EXTENSioN PoLE
1. Attached the pole as described in
''Assembly''.
2. Connect the JawSaw to extension cord.
Connect extension cord to power supply.
NoTE: The JawSaw is quite heavy on the end
of the extension pole.
Add the pole attachment when cutting limbs
above shoulder height and remove the pole
saw when cutting limbs at or below shoulder
height.
3. Lift JawSaw with extension pole upward
one step by one step (See Fig. E). To raise
to the vertical position, lift by the JawSaw
first, then hand over hand along the pole.
4. Before cutting a high branch, consider all
the same points detailed in the "Trimming
Branches" section in the instruction
manual for JawSaw but pay particular
attention to the likely path of the falling
branch.
8 8
WArNiNg: Do not stand directly
below a branch being cut. keep
bystanders far away. Do not stand on a
ladder or other type of unstable support
while using the tool. Do not use the tool
near cable, electrical power or telephone
lines. keep 10' (3m) away from all power
lines. (See Fig. F-i)
5. Position the Jaw perpendicularly on the
branch being cut.
NoTE: Maximum cutting capacity of
JawSaw is 4'' (100mm).
6. One hand should firmly grip the push
handle of the extension pole. The other
hand should hold the metal portion of the
pole or the sliding handle on the pole (See
Fig. J).
7. Complete the cut as described in
"Trimming Branches" .
8. At the completion of the cut, be ready to
immediately support the weight of the
entire tool as the branch falls.
WArNiNg: Do not let the JawSaw
fall to the ground at the completion
of the cut, this may damage the tool.
Extension Pole For JAWSAW
TM
En