Maverick ScoutRC MSC-30BR-SCOUT-WP Mode D'emploi page 6

Turning on the power
Turn on the transmitter switc
indicator will light up.
Turn on the receiver. The automatic set-up of the factory
set speed control should have been completed. If you
experience any problems with the speed control settings
refer to the Electronic Speed Control Section for correct
setup information.
Turning off the power
• Turn off the receiver switch.
• Turn off the transmitter switch.
•
Binding the Transmitter and Receiver
You may need to setup your transmitter to 'bind' with the receiver if you change to a new receiver or for any reason
lose signal.
•
• Turn the power switch on the transmitter to the ON position.
• Press and hold the receiver setup button, then turn the power switch to the ON position.
•
•
receiver is continuously lit.
Power LED
ceiver.
6
installed AA batteries have
there will be an audible beep if
the batteries need replacing.
1