Aligning The Panel - Dacor DRW24980RAP Instructions D'installation

Installation Instructions

19. Aligning the Panel

NOTE
Each custom panel comes with 12 dedicated screws for fine-tuning. Use a minimum
number of screws to fine-tune the custom panel with the cabinet. Once fine-tuning is
complete, fix the custom panel with the top nut.
There are two panel-adjustment mechanisms at the top and two at the bottom of the door.
Adjust the panel so it aligns with the surrounding cabinetry.
The gap between the cabinet and the panel must be:
• 1/8" (3 mm) on top
• 1/8" (3 mm) on the side for single installation
• 5/32" (4 mm) on the side for pair installation
1/8" 1/8"
1/8" 1/8" 5/32" 5/32" 5/32"
52 English
Dacor_BRW9000R_IM_DA68-03621J-02_EN.indd 52 2020-10-19 10:53:11