The Keypad; Operating Mode; Calibration Mode - Fluke Networks MICROSCANNER PRO Mode D'emploi

ENGLISH - 4
MICROSCANNER

The Keypad

When turned on, MICROSCANNER will flash the
LCD power-up test and then resume the test
mode that was last executed. MICROSCANNER
will turn off automatically when no cable is
detected and no key has been used for 10
minutes.
Press to quickly change pairs or adjust
values. The keys are only active if the
indicators are shown on the display

Operating Mode

Press MODE to select the desired test. The
available modes are: WIREMAP - OFFICE
IDENTIFIER - LENGTH - TONER

Calibration Mode

+
Turn the MICROSCANNER OFF, then hold the
MODE key down while pressing the ON key to
start 'Calibrate' mode. Use MICROSCANNER to
calibrate cable lengths of more than 50 feet (15
meters) and up to 1500 feet (457 meters.)