TEFAL STORE'INN DO301EA2CH Mode D'emploi page 33

• It is only now that you can lift and remove the bowl from the motor unit.
3 : Mixing/chopping/kneading
ACCESSORIES USED:
(b)
• Bowl assembly .
(c)
• Drive pin .
(d)
• Multi-purpose blade
FITTING THE ACCESSORIES:
(b3)
• Fit the bowl onto the motor unit
• Slide the multi-purpose blade
(a1)
.
• Place the ingredients in the bowl.
• Fit the lid (b2) and lock it onto the bowl
• To remove the bowl-lid assembly: release the lid then release the bowl.
KNEADING/MIXING:
• Turn the speed selector
You can knead up to:
- 1 kg of heavy pastry, such as: white bread dough, short crust pastry, etc. in 60 seconds.
- 800 g of special bread dough such as: rye bread, wholemeal bread, multi-grain bread, etc. in 60 seconds.
You can mix up to:
- 1.2 kg of light mixture, such as: biscuits, sponge cake, etc. in 1 min 30 to approximately 3 minutes.
You can also mix up to 1 litre of pancake or waffle batter etc. in 1 min to 1 min 30.
CHOPPING:
• Turn the speed selector
You can mince up to 600 g of food such as:
. raw or cooked meat (boned, gristle removed and cut into cubes).
. raw and cooked fish (without skin or bones).
. hard foods: cheese, dried fruits, certain vegetables (carrots, celery, etc.).
. soft foods: certain vegetables (onions, spinach...).
BLENDING:
• Turn the speed selector
You can mix up to 1 litre of broth, soup or stewed fruit in 45 seconds.
ACCESSORIES USED:
(b)
• Bowl assembly .
(c)
• Drive pin .
(f)
• Appropriate insert (depending on model).
(g)
• Insert support .
FITTING THE ACCESSORIES:
(b3)
• Fit the bowl onto the motor unit
(f)
• Fit the chosen insert
possible through the insert
(a1)
.
(b2)
• Fit the lid and lock it onto the bowl
• To remove the bowl-lid assembly: release the lid, then release the bowl.
.
(a)
and lock it in place.
(d)
onto the drive pin
(b3)
.
(a3)
to position 2 to start.
(a3)
to position 2 to start, or for better chopping control, choose the pulse position.
(a3)
to position 2 to start.
(a)
and lock it in place.
into the insert support
(f)
, and lock the assembly, then fit it onto motor unit drive
(b3)
.
(c)
, and position this assembly on the motor unit drive
(g) (c)
, push the drive pin
31
4 : Grating/slicing
Ensure that the
metal drive pin (c)
as far as
is inserted into
the centre of the
lid (b2).
GB