AGPtek S1B Manuel De L'utilisateur page 9

 Splash Proof Handling
The Bluetooth Speaker can handle a brief jet of water on its surface (IPX4 water resistant).
However, it should never be operated under running water and under no circumstance it
should never be fully immersed in water. Before use the Shower Bluetooth speaker in
bathroom, make sure that the splash proof "Rubber Seal Cover (9)" is tighten closed at
the right position.
After used in bathroom, always wipe the outside of the cabinet thoroughly if it becomes
wet with moisture or water splashes. This will help to prevent the internal parts of the unit
from entry of water and possible moisture damage.
Note: If water get into the USB socket, please always clean the water thoroughly before
charging the device.
 Disclaimer
Updates to Firmware and/or hardware components are made regularly. Therefore some
of the instruction, specifications and pictures in this documentation may differ slightly
from your particular situation. All items described in this guide for illustration purposes
only and may not apply to particular situation. No legal right or entitlements may be
obtained from the description made in this manual.
 Troubleshooting
No power
No sound
No radio station
No response from
speaker
 Recycling
To ensure the correct waste treatment of the product and battery, please
dispose them in accordance to any applicable local laws of requirement for
disposal of electrical equipment or batteries. In so doing, you will help to
conserve natural resources and improve standards of environmental protection
in treatment and disposal of electrical waste (Waste Electrical and Electronic
Equipment Directive).
 Check battery is it charged with enough energy.
 Check whether the device is in power OFF mode.
 Check whether volume level is in lower position on your
speaker and mobile phone or PC/Mac.
 Make sure that your Bluetooth device is within the
effective operation range.
 Check whether the Bluetooth device is paired.
 Check whether the Bluetooth device show connected.
 Check if you have selected the correct audio source.
 Check whether the FM station is tuned in correct
frequency and programmed.
 Restart the speaker by power Off and On.
7