Acksys AirXroad Guide D'installation Rapide page 28

QUICKLY EVALUATE AP & BRIDGE MODES
Quickly evaluate the ACKSYS device in AP role
 You need a second computer (PC2) with a working Wireless connection.
 Set up the PC2 Wireless network interface according to the default parameters of
the ACKSYS AP device (802.11gn, SSID "ACKSYS", no security).
Quickly evaluate the ACKSYS device in client role
You need two ACKSYS devices, and a second computer (PC2) with a wired LAN
connection.
 Set up the IP addresses according to the picture above and set the device
connected to PC2 to Client (infrastructure) role.
From each PC, start a command prompt and run the ping command to verify the link.
From PC1: type ping 192.168.1.2, verify the answer returned by PC2
« Answer from 192.168.1.2... »
From PC 2: type ping 192.168.1.1, verify the answer returned by PC1
« Answer from 192.168.1.1... »
Notice: The State LED is flashing until the bridge connects to the
- -
8
AP.