D-Link DNS-323 Guide D'installation page 7

1. Access the drive bays by sliding the faceplate up until it unlatches
from the device.
2. Once the faceplate is unlatched, pull it off of the device, exposing
the drive bays.
3. Insert a 3.5" SATA hard drive into each available drive bay.
Make sure to align the drive connectors to the endpoints in the
DNS-323. Gently push the drive in until it connects.
Note: If only one 3.5" SATA drive is
available place this drive in the LEFT
bay with the opening (front) of the
DNS-323 facing you.
7
Hardware Installation