Duronic JE8 Manuel D'instructions page 8

Juicing
1. Before use, make sure that the machine is turned off. This will avoid
damage or injury during the assembly of the device.
2. Before juicing, make sure that the filter and the pulp container are
assembled, correctly and that there is no contact between the filter and the
transparent cover. Put the transparent cover on, put the handle into place and
then turn on the machine.
3. Assemble according to the diagram of components shown in the manual.
Turn on the power supply, press the on switch and allow the machine to run
for no more than 5 sec. Put prepared vegetables or fruit into feed port of the
juicer, press with the food pusher, evenly, firmly and slowly. The juice will
pour into the juice container.
4. Note: When pressing food with the food pusher, force should be evenly
applied. Press the food pusher slowly. Sudden movements will result in
less juice.
Operating Time
This juicer has three settings (O for stop, I for light power, II for strong power).
For juicing of hard fruit, select the second setting and for soft fruit use the first
setting. Operate for 1 minute, rest for a minute, and then continue use.
After the above cycle has been repeated 3 times, stop for 15 mins to allow the
juicer to cool. By doing this, the service life of the machine will be prolonged.
8