Pre-Set Pacer (Pacer Memory); 6�9�1 Pacer Memory Setting - Conrad 86 01 12 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2�
Press "Split/Reset" (D) and hold it down for 2 seconds to reset pacer
data (distance and steps)�
Stand-alone pacer operation
1�
The pacer operated without any other functions being run�
2�
Press the "Start/Stop" (C) button start or stop
3�
Press the "Split/Reset" (D) to clear pacer data�
A continuous beep sounds, if distance or pace counter overflow.
To enable the pacer again, press "Split/Reset" (D) and hold it
down for 2 seconds to reset all pacer data�
6.9

Pre-set pacer (pacer memory)

6.9.1
Pacer memory setting
Pacer setting is only possible when the stopwatch in the
chronograph mode is reset to "0" and the pacer is not running�
1�
Press the "Select" (A) button to choose the memory location� Each
press switches to the next location� The memory number (MR 1-9) is
displayed�
2�
When at any one memory location, press the "Select" (A) button and
hold it for 2 seconds� The beeper frequency blinks�
3�
Press the "Start/Stop" (C) or "Split/Reset" (D) to set the beeper
frequency in increments/decrements of 5 (range 30 - 240 bmp)�
4�
Press the "Mode" (B) button to confirm and to set the duration for each
pacer setting� Press the "Start/Stop" (C) or "Split/Reset" (D) button to
set the respective values�
5�
Press "Mode" (B) to set the seconds� The seconds blink�
6�
Press the "Start/Stop" (C) or "Split/Reset" (D) button to set the second
values�
7�
Press "Mode" (B) to confirm and set the minutes. The minutes blink.
8�
Press the "Start/Stop" (C) or "Split/Reset" (D) button to set the minute
values�
9�
Press "Mode" (B) to confirm and set the hours. The hours blink.
10�
Press the "Start/Stop" (C) or "Split/Reset" (D) button to set the hour
values�
11�
Press "Mode" (B) to confirm and set the present memory setting
to "ON" or "OFF� "On" or "OFF" blink� The stored pacer program is
activated or deactivated. Press "Mode" (B) to confirm the settings.
12�
Repeat the same steps of the setting procedure for the other nine
memory locations�
27

Publicité

Table des Matières
loading

Table des Matières