Operation - Westinghouse WES41-3000 Manuel D'utilisation

8. OPERATION

We recommend adjusting the chair angle before powering up the chair. This way, the massages will
be done correctly.
Back section up and down adjustments
Press this button
Press this button
Then, press on the power On/Off button
automatic massage mode. There are five automatic massage modes. You can interrupt the automatic
massage mode at any point by shutting off the unit. The massage chair will then return to its original
position.
If you prefer to use the manual massage mode, you can choose the type of massage you want (Shiatsu,
knead, tap, etc.). The massage chair will then use the massage mode you have chosen.
Automatic massage modes
A. Press on the 'adjust shoulder' buttons
your preference.
B. Press one the Automatic massage mode button of your choice.
After the mode is finished, the chair will get back to its original position.
Manual mode
By pressing repeatedly on the mode button
prefer: Knead, Tap, Knock, Knead & Tap and Shiatsu. An LED light will confirm the mode.
During the knead massage mode, you can adjust the speed.
During the Tap massage, you can adjust the speed and width.
During the Knock massage, you can adjust the speed and width.
During the Shiatsu massage, you can adjust the speed and width.
During the knead & Tap massage mode, you can adjust the speed.
Upper and lower body areas massage adjustments
The massage mechanism of the WES41-3000 moves from the neck area to the lower back area.
You can however adjust the area on the back where you want the massage to be done.
to lower the back and raise the leg and foot section.
to lower the leg and foot section and raise the back.
, ,
to start the massage.
or to adjust the massage chair course length to
, , ,
you can activate the massage technique you
You can choose another