Linksys Instant Wireless Serie Guide De Démarrage Rapide page 46

COPYRIGHT & TRADEMARKS
Copyright © 2002 Linksys, All Rights Reserved. Instant Wireless is a trademark of
Linksys. Microsoft, Windows, and the Windows logo are registered trademarks of
Microsoft Corporation. All other trademarks and brand names are the property of their
respective proprietors.
FCC STATEMENT
The Instant Wireless™ Wireless Access Point Router with 4-Port Switch has been test-
ed and complies with the specifications for a Class B digital device, pursuant to Part
15 of the FCC Rules. These rules are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used according
to the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which is
found by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment or devices
• Connect the equipment to an outlet other than the receiver's
• Consult a dealer or an experienced radio/TV technician for assistance
FSG-BEFW11S4 ver. 3-21008 TE
90
Table of Contents
Introduction
Step 1: Connect the Router
Step 2: Configure the PCs
Step 3: Configure the Router
Help
Configuring Wireless Security
Configuring Wireless
Security in Windows XP
For product support and product registration, contact us at the addresses below:
E-mail
Web
100
105
110
113
europe-support@linksys.com
latam-soporte@linksys.com
http://www.linksys.com/international
92
94
96
91