Nowsonic AUTARK LED MASTER II Mode D'emploi page 7

www.nowsonic.com
Outlets and controls on the rear panel
The following outlets and controls are available on the top panel of
Autark Master :
LED II
Nowsonic Autark LED Master II
1. DMX OUT socket
Connect a standard cable (not supplied) to the
XLR
The pins of this female
XLR
Wiring
Pin 1: ground (shield)
Pin 2: signal inverted, DMX
Pin 3: signal, DMX +
The signal is output in the
connect the cable to a
DMX
NOTE: The Master
LED
setup. Therefore, all following
as slave units.
2. socket
DC INPUT
Connect the included wall power supply with the
et (coaxial plug, + = inner contact,- = outer contact). If the supplied
power supply is not available, you can use any
matches the requirements (9–12V, min. 300mA).
3. switch
POWER
POWER
The switch turns the
7
User manual
DMX OUT
socket are wired as follows:
-
format. You must therefore
DMX 512
-capable input of the slave device.
works always as the master in any
II
devices must be configured
DMX
DC INPUT
adapter as long as it
AC
LED Master II on and off.
GB
socket:
DMX
sock-