Publicité
Les langues disponibles
Les langues disponibles
Upper Post
Low Post
Air Cylinder
Wheels
PREPARATION
Before Use
1. Verify that the product and application are compatible, if in doubt contact Omega technical service.
2. Before use, read the operator's manual completely and familiarize yourself thoroughly with the product and its
components, and recognize the potential hazards associated with its use. Know your jack and how it operates
before attempting to use.
Assemble handle
Attached handle to the handle bracket on cylinder set with bolt and nut provided. Refer to parts drawing (pg. 6) for
component location.
Prepare air system
!
CAUTION: Air source must not exceed 200 psi maximum.
1. Connect a union fitting (sold separately) to the air supply inlet (ref. Fig. 2).
2. Attach 1/4" NPT coupler (sold separately) to union fitting if desired.
3. Frequent, but not excessive lubrication is required for best performance. Too much oil will collect inside jack
and be expelled during exhaust cycle. An automatic inline oiler is recommended, but oil may be added manually
before operation or after approximately 1 hour of continuous use. Pour 1 teaspoon of good quality air tool
lubricant into air supply inlet of control valve.
4. Dirt and water may accumulate inside jack during use. An inline filter/dryer is recommended.
5. Air Jack/Support Stand is now ready for use.
!
WARNING: Never use more than one extension with this unit. Using more than one extension causes the load
to be lifted beyond the maximum designed safety lifting height, which could cause loss of load.
Check the jack
1. Examine the jack for broken or damaged parts. Roll the jack to ensure that it rolls freely and smoothly.
2. Raise and lower the unloaded saddle throughout the lift range to ensure proper operation before placing any load
on the product.
3. Replace worn or damaged components with Omega
Lubricate as instructed in Maintenance Section.
Saddle
Exploded Post
Lock Pins
Lock Pin Holder
Post Holder
Figure 1 - Air Jack/Support Stand Components
replacement parts only
3
Air Control Valve
Air Hose
Handle
(see Replacement Parts section).
Handle Grip
Publicité
