D Light AURA Manuel D'usage page 7

HOW TO PREPARE THE TREATMENTS
Before starting treatments, prepare the treatment area by thoroughly cleaning the skin and remove
makeup. Hair must be shaved with a razor or a hair clipper, it is preferable to use a clipper as you
immediately obtain an optimal length of 1mm, and maximizes the absorption of pulsed light (in
epilation treatment), using the clipper will also avoid any skin irritation.
Given that the pulsed light is absorbed by dark colors, it is necessary to protect small, dark
birthmarks and tattoos, cover it with white eyepencil makeup, or with a specific product like the D
Light Patch Pro.
Do not let the pulsed light pass on large or irregular areas! In
the presence of doubt, ask your dermatologist before initiating
treatments!
Do not use the appliance on naturally dark
complexion or on tanned skin!
Do not use the pulsed light on varicose veins and any type of skin
lesions
SELECT ENERGY LEVEL
It is always advisable to begin at the lowest energy level and gradually increase to find the right
intensity according to your own tolerance. The energy level is selected by repeatedly pressing the
energy button (10) after the machine has been started.
As the enegry level increases, so does the results, as well as the risk of possible side effects.
If blistering occurs on the skin, or if you feel burning,
IMMEDIATELY STOP using the device.
- GB
10
EPILATION TREATMENT
The D Light Aura epilation treatment is suitable for all body areas that have hair except the scalp,
male beard, eyebrows, genital and perianal areas.
Any birthmarks or tattoos on the area to be treated must be covered before starting the treatment,
to protect them, you can use an opaque white makeup pencil or a specific product like the D light
Patch Pro. Before starting the treatment, it is advisable to wear certified laser safety glasses or
pulsed light safety eyewear, as an alternative, you can close your eyes when the flash is emitted.
Define the area to be treated (can also help by drawing a grid with a white makeup pencil) and
select the appropriate energy level of the skin type when you are ready.
It is always advisable to start at the lowest energy level and depending on your tolerance, if
you experience no discomfort, you can increase the energy level, treatment is more effective
at highest energy level, but the flash takes longer to load. You can choose between two modes
of operation: single flash or scroll. Using the single flash mode, a flash is emitted everytime the
Flash button (2) is pressed. The scroll mode is activated by holding the Flash button (2) down for
3 seconds, then you can release it and the device will emit flash repeatedly whenever the Flash
window will come into contact with the skin. To turn off scroll mode, just press the Flash button (2)
once and the appliance resumes to function on single flash mode.
When the Flash window is correctly in contact with the skin and the machine is ready for the
Flash, the display starts flashing. It is recommended to radiate 1, maximum 2 times on each
treated area then proceed and move to the next area.
EPILATION TREATMENT CYCLE
For the first 3 months, it is advisable to proceed with 1 treatment per week or every 2 weeks if
you are also doing IPL photorejuvenation or acne treatments on the same area, it is important to
spend at least one week between other treatments by alternating Epilation to the others. The skin
should be hairless after finishing the first 3 month cycle, therefore there will only be maintenance
sessions needed when the hairs begin to reappear (usually a session every 2 or 3 months,
depends on the of individual growth rhythm).
GB -
11