Scodif REC 60 PM Notice D'installation page 22

2
3
If the water has a Water block (in option), please continue your installation as
Option: Waterblock and pressure reducer
1
8.
Filter connection (in option).
Turn off the water supply. Empty water pression of the circuit.
Pull off the stem elbow. Connect the tube+rounded part (1)
1
on the filter entrance (cf photo). Respect water flow circula-
tion (see the arrow).
CAUTION
9.
Turn on the water supply and flush out the filter until the
water is clear (about 5l of water). Turn off the water supply.
10.
Connect the tube+rounded part (2) on the filter outlet
and put the filter into place (3). Turn on the water.
11.
Replace the front panel.
12.
Remove the protective film of the body
follow. If not, the installation is finished.
Turn off the water supply and empty the water pressure
into circuits.
Screw the water block (1) (by hand).
Connect the blue 1/4 tube on the water block (2) and turn
on the water supply.
2
Verify the water pressure (no more 3 bars) with a manome-
ter (put it in place of the filter)
If the water pressure exceeds 3 bars, we recommand to
use a pressure reducer. Place it just after the water supply
and just before the waterblock. The pressure reducer re-
duce the water pressure.
:
Do not flush out the filter trought the taps
because it will damage the solenoid.
22