Water Block Unjamming; Filter Replacement - Scodif REC 80 M Notice D'installation

Water block unjamming

Water block OFF
Water block ON
NB: The water block is pre-adjusted in position 2 to be jammed after a 10 litres
continuous use. Beyond this quantity, the water supply system is blocked.

Filter replacement

4
3
5
Should the water block be jammed, you will
have to re-prime
below :
1.
Turn off the water supply.
2.
Press the cold water button on the control
panel to remove residual pressure in the water
system.
3.
Unscrew the plastic connector.
4.
Press the red button to unjam the water
5.
Screw the connector back on the water
block.
6.
Turn on the water supply.
7.
Press the cold water button on the control
panel.
1.
Switch off the electric plug and turn off the water
supply. Press button for put off pressure into the
water circuit.
2.
Disconnect the filter.
3.
Replace it by the new filter as indicated on step
7, 8 et 9, page 23.
CAUTION
Do not flush out the filter throught the
taps because it will damage the solenoid valves.
4.
Switch on the electric plug of the water cooler.
it as explained
24