Machine Operation; Pre--Operation; Burnishing With The Push Model - Nobles BR-2250 Manuel Opérateur Et Piéces

OPERATION

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
WARNING: Fire Or Explosion Hazard: Never
Use Flammable Liquids Or Operate Machine in Or
Near Flammable Liquids, Vapors Or Combustible
Dusts.
PRE- -OPERATION
1. Check battery meter charge level to ensure
batteries are fully charged. See CHARGING
BATTERIES.
2. Sweep or dust mop the floor to remove debris.
Then damp mop or scrub the floor to assure that
dirt is not burnished into the finish.
3. Check that a pad is installed.
4. Check that a dust bag is installed.
5. Make sure floor to be burnished is dry.

BURNISHING WITH THE PUSH MODEL

1. Turn key switch to the "ON" position (Figure 4).
The key ON light on the panel will light green.
2. With the control grips released, step down on the
rear of the pad shroud until the head locks in the
down position (Figure 5).
8
FIG. 4
Home Find... Go To..
3. Remove foot from the pad shroud.
4. Twist the control grips forward (Figure 6). The pad
motor will start and suction will draw the moving
pad to the floor. Immediately push or pull the
machine in the desired direction.
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
ATTENTION: Keep machine moving at all times to
prevent floor damage.
5. To stop, release the control grips. The pad will
automatically lift from the floor until the grips are
activated again.
FIG. 5
FIG. 6
BR- -2250/BR- -2500 (08- -05)