Accessories - Ad Rem Veinoplus 1.2 Mode D'emploi

Appareil qui stimule les muscles du mollet et améliore le retour veineux
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The maximum r.m.s. value of current density on recommended electrodes
does not exceed 0.2 mA/cm2
The maximum AC output power of VEINOPLUS is limited to 0.01 W r.m.s.
The maximum DC output power of VEINOPLUS is limited to 0.0001 W.
Rates of muscle pulsations during use:
The rates of stimulated muscle pulsations are similar to heart beats. They are
programmed to accelerate during each use from 60 BPM (Beats Per Minute)
for the first 5 minutes of treatment, to 75 BPM for the following 5 minutes,
then to 90 BPM for the next 5 minutes and finally to 105 BPM for the last 5
minutes of use session. These pulsation rates correspond to frequencies in a
range from 1 Hz to 1.75 Hz.
VEINOPLUS is supplied with all the accessories required for an easy, safe and
effective treatment. These include two VEINOPLUS PACK self-adhesive skin
electrodes, one cable, one 9V alkaline battery and one instruction manual.
In compliance with transport regulations in some countries, the battery may
not be delivered with the device.
Electrodes and how to use them:
The VEINOPLUS PACK electrodes are reusable. It is recommended that the
same set of electrodes is used by the same person. Used electrodes should be
replaced as soon as they no longer adhere or become dirty. Specific instructions
for use and maintenance of the electrodes are included in their package.
Recommended electrodes:
VEINO PLUS has been clinically tested, and its effectiveness is optimal when
VEINOPLUS PACK 8X13 electrodes are used. For effective and safe treatments
it is recommended to use only the original electrodes branded VEINOPLUS
PACK. No other brands or types of electrodes are recommended for use with
VEINOPLUS. The replacement electrodes when purchased in pharmacies or
elsewhere should be in original sealed packages VEINOPLUS PACK. If, by
mistake any other types of electrodes are used with the VEINOPLUS, its
effectiveness can be severely reduced but its safety will not be affected.
This is due to inherent design of electronic circuitry inside the VEINOPLUS,
which automatically limits the effective current density on electrode contact
if smaller or larger size auto-adhesive electrodes are used by mistake. Metal
plates for skin contacts instead of pre-gelled VEINOPLUS PACK electrodes can
be used only by, and at the sole responsibility of health professionals.

ACCESSORIES

16

Publicité

Chapitres

Table des Matières
loading

Table des Matières