Commissioning - Funktel FC1 Guide Utilisateur

Mobility Server I 33 / CS I55 • I 1/3/5

Commissioning

If your business handset is not yet assembled completely
If the business handset is not completely assembled when you receive it,
you must
• Insert the MEM-Card (see page 52),
• Install the rechargeable battery pack (see page 52) and
• Remove the protective film from the display, if necessary.
GB
• Finally your service team must register the business handset with your
telephone system.
Your business handset is then ready for operation.
• Now connect the charger (see page 53).
If your business handset is already fully assembled
If the business handset is already completely assembled and registered
with your telephone system when you receive it, you only need to connect
the charger (see page 53).
MEM-Card
You can only use your business handset to make and receive telephone
calls if a MEM-Card is inserted. It performs the memory function for your
important business handset data, as well as your personal settings and
your telephone book.
If you switch handsets you can remove the MEM-card from the ancient
one and insert it into the new one. Thus, you can use the MEM-Card
together with the new handset to make and receive telephone calls
immediately.
Attention!
Read and follow the safety instructions about the handling of
explosion-proof units from page 76 to 79.
51