Maintenance; Scheduled Maintenance Table - Nilfisk Advance Terra 5200B Mode D'emploi Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTRUCTIONS FOR USE

MAINTENANCE

The lifespan of the machine and maximum operating safety are ensured by correct and regular maintenance.
The following table summarizes the routine maintenance required. The intervals indicated can be changed to suit working
conditions. These must be defined by the person in charge of the maintenance.
WARNING!
These operations must be carried out with the machine off, the ignition key not inserted and (if
required) the battery disconnected.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance operations must be performed by skilled personnel, or by an Authorized
Service Center.
This manual describes only the easiest and most common maintenance procedures.
NOTE
For other maintenance procedures contained in the Scheduled Maintenance Table, refer to the
specific Service Manual that can be consulted at any Service Center.

SCHEDULED MAINTENANCE TABLE

Maintenance operation
Battery fluid level check
Hopper lifting system hydraulic oil level
check
Motor-to-main broom belt visual
inspection and tension check
Skirt height and operation check
Side and main broom height check
Frame dust filter cleaning and integrity
check
Pocket dust filter cleaning and integrity
check
Filter shaker operation check
Brake adjustment
Nut and screw tightening check
Drive wheel chain tension check and
cleaning
Steering chain cleaning
Vacuum hose integrity check
Pulley-to-main broom belt replacement
Motor-to-main broom pulley V-belt
replacement
Hopper gasket integrity check
Hopper lifted position control microswitch
adjustment check
Hopper horizontal position control
microswitch adjustment check
Motor carbon brush check and
replacement
Hydraulic oil replacement
(*): for the related procedure, refer to the Service Manual.
(1): or before each start.
(2): and after the first 8 running-in hours
(3): replace hydraulic oil for the first time after 500 hours, then after 2,000 hours or every year
10
Every 10
On delivery
hours
(1)
Every 50
Every 100
hours
hours
(1)
(*)
(*)
(*)
(*) (2)
(*)
(*)
(*)
Terra™ 5200B – 146 1996 000(2)2004-08
Every 200
Every 400
hours
hours
(*)
(*)
(*)
(*)
(*)
(*)
(*) (3)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

908 4508 010

Table des Matières