Hanseatic SY-6005B2 Manuel D'instructions page 39

Installation
2. On the line indicating the lower edge of the extraction hood, use a pencil and
carefully mark the centre on the wall.
If possible, move the cooker so that there is sufficient space to install
Important!
the extraction hood. Use a stable ladder and get a second person to
assist you.
3. Push the lock on the grease filters 1a backwards and remove the grease
filters 1a carefully downwards.
4. Hold the extraction hood below the wall unit so that the centre of
the extractor hood and the vertical guide line are in alignment (only
for circulating air mode: The hood should protrude to the front of the
wall unit so that the upper ventilation slots are not covered).
5. From the inside of the extraction hood, a second person should mark
the four holes to be drilled on the unit (only for extraction mode with air
discharge upwards: also mark the air discharge aperture).
6. At the 4 marked locations, drill the holes diameter ø 5 mm, in the unit.
7. As necessary, cut out the marked air discharge aperture in the unit.
– For this, use a wood drill and drill a ø 8 mm hole in the inside of
the circle.
– Use a jig saw and cut out the circle.
– Use sandpaper to smooth the edges.
14
1a
Preparation