Nicols DP 615II Guide D'utilisation page 12

Operations
2.1 Beginning Menu: Apply power to this unit, firstly the LCD reads "Welcome To Use", then Beginning Menu is
displayed. Beginning Menu consists of a row of dynamic images and a row of characters , the first
row represents the intensity value, and the second row indicates the channel.
2.1.1 Adjust channel intensity temporarily: Tap the channel button to select desired channel intensity, each tap will change
intensity once. Pressing the button for two seconds changes channel intensity quickly. Tap ESC button, changing
direction of channel intensity will be reversed.
2.1.2 Adjust whole intensity temporarily: Tap UP/DOWN button to select desired intensity, each tap will change intensity
once. Pressing the button for two seconds changes channel intensity quickly.
2.2 Basic Menus: In Beginning Menu, tap MENU button to enter Basic Menus system. There are 5 menus: DMX Fail,
Phase Correction, DMX Address, Preheat and Curve, you can use UP/DOWN button to scroll through
the menus. Tap ESC button to leave Basic Menus system.
2.2.1 DMX Fail
1.Tap UP/DOWN button to scroll to DMX Fail menu.
2.Tap MENU button to enter sub-menu system. You can use UP/DOWN button to select Hold/Analog/Prog. 1-12.
[Hold]: Last received DMX signal is held.
[Analog]: The analogue input(0-10v) is activated.
[Prog. 1-12]: Starts internal programs 1-12.
3.If you select Hold or Analog, you can tap ESC button to exit.
4.If you select Prog. 1-12, tap ESC button, speed menu is activated. You can select the chasing speed from 0.1 to 20
seconds using UP/DOWN button. After you've finished your setting, tap ESC button to exit.
2.2.2 Phase Correction
1.Tap UP/DOWN button to scroll to Phase Correction menu.
2.Tap MENU button to enter sub-menu system. You can use UP/DOWN button to select Yes/No.
[Yes]: Linear dimming is activated.
[No]: Non-linear dimming is activated.
3.Tap ESC button to exit.
PAGE 12 OF 13