LEXIBOOK DVDP1 07 Mode D'emploi page 8

WARNING: Malfunction or loss of memory may be caused by strong frequency
interference or electrostatic discharge. Should any abnormal function occur, remove the
battery and insert it again.
Corrosion, oxidation, battery-leakage and any other gradually acidic defect of this
nature will invalidate the guarantee.
Using the remote control
• Effective distance between the remote control and DVD player remote sensor is three
metres.
• When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light
shines on the remote sensor of the unit, the remote operation may be unstable.
• When the battery becomes weak, the operating distance of the remote control reduces
significantly and you need to replace the battery.
Your DVD player is equipped with a built-in rechargeable lithium battery.
Fully charge the battery before using it for the first time.
1. Plug the AC / DC or car adaptor into the jack on the back of the DVD player and insert
the plug into a mains wall socket or car cigarette lighter. When the unit is turned on, the
power indicator is red.
2. Once you connect the unit to the AC/DC adaptor or car adaptor, the lithium battery will
be charged.
3. When the battery is being charged, the battery indicator flashes green.
4. When the battery is fully charged, the indicator becomes red.
Charging time
Approx. 3 to 4 hours
Note:
• The playback time may vary based on pattern usages of the DVD player.
• Only use the adaptor supplied with the DVD player. Do not use any other adaptor.
• The socket-outlet should be installed near the equipment and should be easily
accessible.
WARNING: Malfunction or loss of memory may be caused by strong frequency
interference or electrostatic discharge. Should any abnormal function occur, unplug the
AC / DC adaptor from the mains socket and plug it back in.
8
DVDP1_07IM1353_30Aug_V09.indd 8
Charging the built-in lithium battery
CHARGING TIME / PLAYBACK TIME
Playback time
Approx. 1½ to 2 hours
30/08/2013 4:19 PM