Molpir COMPACT 1.6 Mode D'emploi page 12

COMPACT 1.6
EN
A
Equipment does not start.
B
When connecting the power wire of the
unit, it makes intermittent beeps.
C
The symbol appears in the control
panel
D
Equipment does not respond to remote
control.
E
One compressor do not.
F
E0 flashes in the control panel.
G
E6 flashes in the control panel.
H
The condenser fan does not work.
I
The centrifugal blower does not work.
Symptom
• Fuse is blown.
• Power cable is disconnected or cut.
• Control panel and electronic control
connection cable.
• Battery is low.
• Controls are not programmed anymore.
• Controls battery is flat, led is not turned on.
• Electronic control is broken down.
• Faulty controls.
• Bad connection of terminals.
• Faulty control module.
• Broken down compressor.
• lack of battery voltage
• Poor return air sensor terminal or cable
contact.
• Return air sensor faulty.
• Poor anti-freeze sensor terminal or cable
contact.
• Anti-freeze sensor faulty.
• Condenser fan blocked or faulty.
• Electronic control faulty.
• Terminals disconnected.
• Electronic control failure.
• Centrifugal blower defective or terminals
disconnected.
12
Cause