Epson Expression Home XP-4100 Guide Rapide page 3

■
When using TCP/IP, make sure your network's DHCP option is enabled (your router
manufacturer will be able to assist you with this setting).
■
Print a network status sheet from the product's control panel. Load a few sheets of
plain paper in your product. Press
>
Settings Network Status
■
Remove and reinstall your product software.
Printing a Connection Check Report
You can print a network connection report and check for any error codes and messages to
solve problems you may encounter with network connections.
1. Load a few sheets of plain paper in your product.
2. Press if necessary, and select
>
Print Check Report
3. The connection report prints. Check for any error codes and follow the solutions on
the report.
Below are a few common error codes and solutions. If you do not see your error code listed
here, see the online User's Guide.
Error code E1: Make sure your router, access point, and/or hub are turned on, and the
network cable is securely connected to your device and to your product.
Error code E2, E3, or E7:
■
Make sure your router or access point is turned on, and is correctly connected to your
computer or network device.
■
Turn off the router or access point, wait about 10 seconds, and turn it on again.
■
Move your product closer to your router or access point, and remove any obstacles
between them.
if necessary, and select
>
Print Status Sheet
Settings
.
Message or solution
. Then press the
>
Network Settings
Error code
Printing a Connection Check Report
>
Settings Network
start button.
>
Connection Check
3