Fein 9 01 04 007 01 0 Notice D'utilisation page 9

3 41 01 083 06 0.book Seite 9 Dienstag, 26. Februar 2008 3:02 15
9 01 04 007 01 0
Operating instructions for magazine holder.
Overview.
1 Screwdriver bit
Only use the special screwdriver bit.
2 Release knob
Press to remove the sliding piece dur-
ing maintenance work.
3 Grooved knob for adjusting the
screwdriving depth
For altering the screwdriving depth of
the screw in the material.
4 Screw stop
With grooved knob (a) for presetting
to the length of screw used.
5 Screw strip
For mounting, fit the screw strip into
the screw strip guide (b) and across
the tooth points of the notched discs.
For your safety.
Before using this device, read and
comply with:
these operating instructions,
the relevant national industrial safety
regulations.
These operating instructions and the
enclosed safety instructions should be
kept carefully for later use and enclosed
with the device, should it be passed on or
sold.
Intended use.
This device is intended for:
commercial use in industry and trade,
as an accessory for FEIN screwdrivers.
especially for use in drywall construction
using screw strips approved by FEIN.
To ensure that the device functions safely,
only use screw strips that have been
approved by FEIN.
Only FEIN magazine screwdrivers with a
spindle collar diameter of 33 mm are suit-
able for driving the magazine holder.
Safety instructions.
!
Risk of injury
Please observe the operating instructions
and safety instructions for the respective
power tool used.
Do not point the device towards oneself
or other persons once it is ready for use.
Only insert a new screw strip when the
device is switched off.
Secure the work piece. A work piece that
is gripped tightly in a clamping device or
vice, is more secure than if held by hand.
Do not allow your fingers to enter the
magazine holder or grasp the place to be
screwed whilst working.
Personal protective equipment.
When using this device wear the follow-
ing protective items:
sturdy shoes, hair net (for long hair).
Handling.
Insert a special screwdriver bit (1) into
the tool holder of the screwdriver.
Push the magazine holder onto the
screwdriver bit and position it as far as
the stop on the spindle collar of the
drive machine.
en
9