Axis 214 PTZ Guide D'installation page 4

Page 4
2. Attach the second bracket (B) to the base of
the camera, using 3 of the supplied screws.
The retaining wire should be attached to
screw 3.
3. Tighten the screws a little at a time in the
numbered order shown here, until all are
securely fastened.
4. Insert the hooks on bracket (B) into the slots
on bracket (A) and push bracket (B) back as
far as it will go.
Ceiling
bracket (A)
Ceiling
bracket (B)
AXIS 214 Installation Guide
5. Push up on the front of the camera and
fasten it using the supplied screws,
starting at the front.
6. Connect the power and network cables
to the sockets on the rear panel.
Retaining
wire
Ceiling
bracket (B)