Replacing Light Bulbs; Troubleshooting - Newage 65901 Manuel D'installation Et D'utilisation

Replacing Light bulbs

Disconnect grill at power source before replacing light bulbs
!
The oil from your fingertips will reduce the life of the bulb. It is recommended to
touch the bulb as little as possible and to wipe the bulb with a cloth after handling
with bare fingers.
Lights: To replace the halogen bulb in your grill you must first remove the lens from the light
housing. To remove the lens from the housing, remove the Phillips screw securing the housing in
place. Snap the lens out of the housing (including the metal bracket). Reach in using your fingers
only, grip the two outside edges of the light bulb, do not grip the top or bottom of the bulb, as it
might break. Insert the new bulb using your clean cloth and gently snap it into position.
Begin by unplugging the grill from the
1
power supply. Remove the screw holding the
light housing to the grill using a #2 Phillips
screwdriver.
With the light cover removed pull the halogen
3
bulb out from light socket.
3
100w/12V
42
www.newageproducts.com
Carefully pull the housing out from grill,
2
it will be attached by electrical wire so do
not pull hard. Remove the clip holding
the light cover to the main light housing.
A
Replace bulb by pushing straight into light
socket. Re-attach light cover, and re-install
4
housing repeating steps 2. and 3. in reverse
order.

Troubleshooting

Please check and confirm the following points before calling Customer
Service.
1. Is there fuel supplied to the grill?
2. Is the main shut-off valve open?
3. Are you using the correct type of fuel for the grill? ( LP grill or Natural Gas grill)
4. Is your propane cylinder empty? Have you recently refilled the propane cylinder? If so, is the
connection tight?
5. Is the grill plugged in to a live electric circuit?
6. Attempt to match light the burner (see page 31). Check to see that other burners on the unit
operate. Clean electrode tip of any debris.
Problem
1. Low heat/ Low flame when control knob turned to "High" - Page 40
2. Uneven heat - Page 40
3. Burners burn with yellow flame, accompanied by the smell of gas. - Page 40
4. Main burner will not light with the igniter, but will light with a match. - Page 40
5. Humming regulator. - Page 40
6. Burners will not cross light each other. Page 40
7. "Paint" appears to be peeling inside lid or hood. - Page 41
8. Burner output on "high" setting is too low. (Rumbling noise and fluttering blue flame at
burner surface.) - Page 41
9. Infrared burner (if equipped) flashes back (during operation the burner abruptly makes a
loud "whoosh" sound, followed by a continuous blow-torch type sound and grows dim.) -
Page 41
10. Electronic Ignition not working. - Page 42
11. Grill and control panel lights not working - Page 42
12. Burner goes out - Page 42
13. Burner goes out when set to low - Page 42
14. Rotisserie won't light - Page 42
15. Rotisserie lights and goes out immediately upon control knob release. - Page 42
www.newageproducts.com
43