Williams-Sonoma K-CUP Mode D'emploi page 7

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SETTING UP YOUR SINGLE-SERVE COFFEE MAKER USING THE GROUND COFFEE ADAPTOR
The ground coffee adaptor allows you to create your own favorite blend of coffee. Personalize your blends
by adding a dash of cinnamon, orange peel, cardamom or vanilla bean for flavoring, to name a few options.
NOTE: For best results, use medium ground coffee.
WARNING: Before brewing, it is recommended the water tank be filled at least to the lowest 6-oz. step.
To avoid damage to your Coffee Maker, never operate your Single-Serve Coffee Maker when the water tank
is empty.
Lift the water tank lid located at the top back of the unit. (See Figure 1.)
Using the desired cup, mug, or tumbler as your measure, add water to the water tank. The water tank has
an easily visible, stepped water level indicator. Add water to the desired fill line to brew one cup of any
hot beverage. The level indicator marks 6-oz., 10-oz., and 15-oz. However, any amount of water may be
added. DO NOT EXCEED the 15-oz. MAX fill line.
Lower the lid.
IMPORTANT: For optimal flavor, distilled water is preferred.
Position the cup under the nozzle and onto the center of the
drip tray cover.
Pull the adaptor compartment's front tab up to unlock and
lift the lid.
Choose the ground coffee adaptor. Fill the reusable ground
coffee adaptor with 1 tbsp of ground coffee for every 1 cup
of water. DO NOT EXCEED the MAX fill line. It is recommended
to use one 1 tbsp of ground coffee for every 1 cup of water.
For stronger or milder coffee, adjust amount of coffee to suit
your taste.
With the handle facing front, place the ground coffee adaptor
into the adaptor compartment. Slide the adaptor handle into
the grooves at the front of the Coffee Maker. (See Figure 6.)
Press the adaptor compartment's lid down firmly. An audible
click can be heard as the lid is locked firmly into position.
Plug the Coffee Maker into a 120V AC electrical wall outlet.
Press the
button to begin the brew cycle.
The red PREHEAT indicator light will begin to flash as the Coffee Maker begins heating the water.
When the water has reached the optimum temperature, the preheat light will go out and the blue BREW
light will illuminate.
The pump will then activate and coffee will begin to stream through the nozzle.
To interrupt the brewing cycle at any time, press the
At the end of the cycle, the Coffee Maker and all indicator lights will automatically turn OFF.
Unplug the Coffee Maker when not in use.
SO-313162_00000_Open kitchen_Single-Serve cm_W&S_IM_r7.indd 5
Figure 6
GROUND COFFEE
button. Then remove the plug from the wall outlet.
PREHEAT
BREW
5
2016-03-02 12:50 PM

Publicité

Table des Matières
loading

Table des Matières