VINCENT SV-122 Manuel D'utilisation page 57

A A k k t t i i o o n n
Change Tone settings
Dim the display
(brightness settings)
Choose the decoding
mode for digital audio
inputs
Reduce the sound's
dynamics (Midnight
mode, Compression)
T T a a s s t t e e B B e e s s c c h h r r e e i i b b u u n n g g
T T O O N N E E
( ( 4 4 ) ) ( ( 4 4 3 3 ) )
Attenuate or increase bass and treble intensity from „-10 dB"
(maximum decrease) to the maximum value of „+10 dB"
S S E E T T ( ( 3 3 8 8 ) )
(maximum increase).
If no change in treble or bass intensity is wanted, turn the TONE
M M U U L L T T I I
function off instead of keeping it unchanged by setting „00 dB" values.
C C O O N N T T R R O O L L
Front panel control: „MULTI CONTROL" changes the values or shuts
( ( 9 9 ) )
the TONE function on/off. Repetitive use of the button „TONE" changes
through the options.
B B A A S S S S ( ( 4 4 5 5 ) )
Remote control: „BASS+" and „BASS-" change bass intensity, „TREBLE+"
and „TREBLE-" change the treble intensity. To activate or deactivate the
T T R R E E B B L L E E
TONE system, press „TONE" followed by „SET+" or „SET-".
( ( 4 4 5 5 ) )
Repetitive use of the „DIMMER" button changes the brightness of the
D D I I M M M M E E R R
frontpanel display. Three different grades of brightness can be chosen.
( ( 2 2 ) )
This function can be used only from the remote control.
The digital audio inputs OPTICAL and COAXIAL (14) of the receiver can
process different digital audio streams (PCM stereo, dts, Dolby Digital).
Only if one of these inputs has been selected, the button „IN.MODE"
located on the remote control allows to determine the mode the signal is
decoded. It is recommended to keep the „AUTO MODE" setting.
AUTO MODE
I I N N . . M M O O D D E E
( ( 3 3 5 5 ) )
PCM MODE
DD MODE
DTS MODE
The setting is global and thus has effect for both digital audio inputs.
Changing of this setting is not necessary and not possible for all analog
audio inputs (CD, AUX1, AUX2, TUNER, 5.1 CH).
Dramatic movie sound requires dynamics, i.e. the ability to show large
differences and fast changes in volume. To keep disturbances to other
people in quiet environments to a minimum, many home cinema systems
offer a function like „Night". Quiet sounds are intensified, loud passages
are dampened. That enables you to comprehend movie dialogues at
N N I I G G H H T T
low system volume levels while high-volume sound effects represent no
( ( 4 4 6 6 ) )
disturbances to others.
Activate this option by a short push on the „NIGHT" button, if repeated,
the "night mode" will be deactivated.
This function can be activated and deactivated only from the remote
control and is only available in the audio playback mode "Dolby Digital".
automatic choice of decoding mode based on identified
audio format
digital audio stream will be decoded as PCM
digital audio stream will be decoded as Dolby Digital
digital audio stream will be decoded as dts
Vincent
57