Westinghouse WFVC001 Instructions page 8

Cleaning the dust bin
1. Be careful not to pull the power trigger.
2. Press the dust bin release button, then remove dust bin carefully.
3. Disassemble the dust bin, then clean the dust bin with a damp cloth.
4. Do not use detergents, polishes or air fresheners to clean the dust bin.
5. Do not put the dust bin in a dishwasher.
6. Clean the cyclone shroud with the brush on the combination tool to remove lint
and dust.
7. Ensure the dust bin is completely dry before install.
8. Close the dust bin base so it clicks into place and is secure.
Washing the filter
Check and wash the filter regularly according to maintain performance. The filter
may require more frequent washing if vacuuming fine dust or if used mainly in High
Speed Level mode.
1. Be careful not to pull the power trigger.
2. Wash the filter with cold water only.
3. Do not put the filter in a dishwasher, washing machine, tumble dryer, oven,
microwave or near an open flame.
EN
4. To refit, place the dry filter back into the top of the machine. Make sure it is
seated properly.
8
WFVC001_Vacuum Cleaner_6L_IB.indd 8 22/10/2019 16:31:56