Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

ASSOCIATE
D
SAVE THESE INSTRUCTIONS.
1.
purchased. You may need to refer to these instructions at a later date.
CAUTION.
2.
To reduce risk of injury, charge only wet cell, lead-acid, automotive type rechargeable batteries. Other types of batteries may
burst causing personal injury and property damage.
3.
Do not expose the charger to rain or snow if specifically warned on the unit not to do so.
4.
Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injury to
persons.
5.
To reduce the risk of damage to the electric plug and cord, pull by the plug rather than the cord when disconnecting the charger.
6.
Make sure the cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
7.
An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result in a risk of fire and electric
shock. If an extension cord must be used, make sure:
a.
That the pins on the plug of extension cord are the same number, size, and shape as those of the plug on the charger;
b.
That the extension cord is properly wired and in good condition; and
c.
If the length of the extension cord is less than 25 feet, use a 16AWG cord, If 50 feet- 12AWG, 100 feet-10AWG, 150 feet-8AWG.
8.
Do not operate the charger with a damaged cord or plug, replace them immediately.
9.
Do not operate the charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman.
10. Do not disassemble the charger unless you are qualified to work on electrical products. If not, take it to a qualified serviceman when service or
repair is required. Incorrect reassembly may result in risk of electric shock or fire.
11. To reduce the risk of electric shock, unplug the charger from the outlet before attempting any maintenance or cleaning. Turning off the
controls will not reduce this risk.
WARNING - RISK OF EXPLOSIVE GASES
12.
a.
WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING
NORMAL BATTERY OPERATION. FOR THIS REASON IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR
CHARGER, YOU READ THIS MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY.
b.
To reduce the risk of battery explosion, follow these instructions and those published by the battery manufacturer and manufacturer of
any equipment you intend to use in the vicinity of the battery. Review cautionary markings on these products and on the engine.
PERSONAL PRECAUTIONS
13.
a.
Someone should be within range of your voice or close enough to come to your aid when you work near a lead-acid battery.
b.
Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes.
c.
Wear complete eye protection, and clothing protection. Avoid touching eyes while working near battery.
d.
If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enter eyes, immediately flood eyes with running
cold water for at least 10 minutes and get medical attention immediately.
e.
NEVER smoke or allow a spark or flame in vicinity of the battery or engine.
f.
Be extra cautious to reduce risk of dropping a metal tool onto the battery. It might spark or short-circuit the battery or other electrical
parts that may cause an explosion.
g.
Remove personal metal items such as rings, bracelets, necklaces, and watches when working with a lead-acid battery. A lead-acid
battery can produce a short circuit current high enough to weld a ring or the like to metal, causing a severe burn.
h.
Use this charger for charging a LEAD-ACID battery only. It is not intended to supply power to a low-voltage electrical system other than
in an automotive application. Do not use this battery charger for charging dry-cell batteries that are commonly used with home
appliances. These batteries may burst and cause injury to persons and damage to property.
i.
NEVER charge a frozen battery.
PREPARING TO CHARGE
14.
a.
If necessary to remove battery from vehicle to charge, always remove the grounded terminal from the battery first. Make sure all
accessories in the vehicle are off, so as not to cause an arc.
b.
Be sure the area around the battery is well ventilated while the battery is being charged. Gas can be forcefully blown away by using a
piece of cardboard or other non-metallic material as a fan.
c.
Clean the battery terminals. Be careful to keep corrosion from coming in contact with eyes.
d.
Add distilled water in each cell until battery acid reaches level specified by the battery manufacturer. This helps purge excessive gas
from cells. Do not overfill. For a battery without cell caps, carefully follow the manufacturer's recharging instructions.
e.
Study all battery manufacturer's specific precautions such as removing or not removing the cell caps while charging and the
recommended rates of charge.
f.
Determine voltage of the battery by referring to the car owner's manual and make sure that the output voltage selector switch is set at the
correct voltage. If the charger has adjustable charge rate, charge the battery initially at the lowest rate.
CHARGER LOCATION
15.
a.
Locate the charger as far away from the battery as the DC cables permit.
b.
Never place the charger directly above the battery being charged; gases from the battery will corrode and damage the charger.
c.
Never allow battery acid to drop on the charger when reading the specific gravity or filling battery.
d.
Do not operate the charger in a closed-in area, or restrict ventilation in any way.
e.
Do not set a battery on top of the charger.
IMPORTANT SAFETY INSTRUCTIONS
This manual contains important safety and operating instructions for the battery charger you have
1
MODEL 6010B
6 – 12 – 24 VOLT
BATTERY CHARGER
OPERATORS MANUAL

Publicité

Table des Matières
loading

Sommaire des Matières pour Associated Equipment 6010B

  • Page 1 MODEL 6010B 6 – 12 – 24 VOLT BATTERY CHARGER OPERATORS MANUAL ASSOCIATE IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS. This manual contains important safety and operating instructions for the battery charger you have purchased. You may need to refer to these instructions at a later date.
  • Page 2: Dc Connection Precautions

    DC CONNECTION PRECAUTIONS Connect and disconnect the DC output clamps only after setting the charger switches to the OFF position and removing the AC cord from the electrical outlet. Never allow the clamps to touch each other. Attach the DC clamps to the battery post and twist or rock back and forth several times to make a good connection. This tends to keep the clamps from slipping off the terminals and helps to reduce the risk of sparking.
  • Page 3 LENGTH OF CHARGE Test the battery for state of charge. Do not charge if it is over 75% charged or the battery is determined to be defective. Set beginning amps charge rate for size of battery and state of charge per charts Charge for length of time per charge, Discontinue charge when the specific gravity of electrolyte reaches 1.260 or above.
  • Page 4: Wiring Diagram

    NEGATIVE POSITIVE CLAMP CLAMP (BLACK) (RED) PROBE STOP/GO LITE STOP/GO LITE MODEL 6010B PARTS LIST Item Description Part No. Transformer ............611386 Rectifier ............... 610364 Fan Blade ............610189 Fan Motor ............610190 Timer ..............611245 Switch w/knob (1) ..........611187 Amps Charge Meter ..........
  • Page 5: Avertissement - Danger Dû Aux Gaz Explosifs

    MODÈLE 6010B 6 – 12 – 24 VOLT MANUEL D'UTILISATION ASSOCIATED INSTRUCTIONS DE SÉCURITÉ IMPORTANTES CONSERVER CES INSTRUCTIONS. Le présent manuel contient des instructions de sécurité et d'utilisation importantes pour l'utilisation du chargeur de batterie que vous avez acheté et qui pourront se révéler utiles ultérieurement.
  • Page 6: Emplacement Du Chargeur

    e. Étudier toutes les précautions spécifiques du fabricant de la batterie tels celles qui concernent le retrait ou non des bouchons de cellules lors de la charge, ou encore le régime de charge recommandé. f. Déterminer la tension de la batterie en se référant au manuel du véhicule et s'assurer que le sélecteur de tension de sortie du chargeur est réglé...
  • Page 7: Période De Charge

    f. Ne pas faire face à la batterie pour effectuer le dernier branchement. g. Pour débrancher le chargeur, suivre en sens inverse les étapes relatives au branchement et débrancher la première connexion tout en se tenant aussi loin que possible de la batterie. h.
  • Page 8: Pour Charger La Batterie

    POUR CHARGER LA BATTERIE Faire les connections a la batterie comme indique dans les instructions précédentes de ce manuel. Déterminer si la batterie est de 6,12 ou 24 volts, puis mettre l'interrupteur sur VOLTAGE DE LA CHARGE a 6V pour une batterie de 6 volts, 12LO pour une batterie de 12 volts ou 24V pour une batterie de 24 volts.
  • Page 9: Instructions D'entretien

    NOIR BLANCHE JAUNE FUSIBLE THERMIQUE PINCE PINCE NEGATIVE POSITIVE NOIR ROUGE SONDE STOP/GO LITE STOP/GO LITE MODEL 6010B PARTS LIST Item Description Part No. Transformateur 611386 Redresseur 610364 Pale de ventilateur 610189 Moteur du ventilateur 610190 Minuteur 611245 Interrupteur à bouton (1)
  • Page 10: Precauciones Personales

    MODELO 6010B 12-6-24 VOLTIOS CARGADOR DE BATERÍA MANUAL DEL OPERADOR IMPORTANTES MEDIDAS SEGURIDAD 1. GUARDE ESTAS INSTRUCCIONES. Este manual contiene importantes medidas de seguridad y operatividad para el cargador de baterías que usted ha comprado. Puede necesitar acudir a ellas en algún momento.
  • Page 11: Colocación Del Cargador

    15. COLOCACIÓN DEL CARGADOR a. Coloque el cargador tan lejos de la batería como los cables de corriente directa lo permitan. b. Nunca coloque el cargador directamente por encima de la batería a cargar;los gases dañarán el cargador. c. Nunca permita que el ácido de la batería pueda caer en el cargador cuando se lee la gravedad específica o al rellenar la batería. d.
  • Page 12 eléctrico. El cargador de la batería es para uso de circuítos de 120 voltios y tiene un enchufe de tierra como aparace en la FIGURA A. Un adaptador temporal como aparace en la FIGURA C, puede usarse para conectar el enchufe a un receptáculo de dos polos, como se muestra en la FIGURA B, hasta que una terminal de tierra adecuada pueda ser instalada por un electricista cualificado.
  • Page 13: Diagrama De Cables

    Apagar todas las luces y los accesorios en el vehículo. Conectar el cargador a la batería según las instrucciones anteriores. Carga rápida la batería en la posición de gama alta por lo menos cinco minutos. Asegúrese de que la batería está recibiendo corriente. Arrancar el coche con el cargador conectado a la batería. Siga el ciclo de trabajo de la unidad.
  • Page 14: Instrucciones De Mantenimiento

    NEGRO BLANCO AMARRILLO FUSIBLE TÉRMICO PINZA PINZA NEGATIVA POSITIVA NEGRO ROJA SONDA STOP/GO LITE STOP/GO LITE MODELO 6010B LISTA DE PARTES Articulo Description N Pieza Transformador 611386 Rectificador 610364 Aspa del Ventilador 610189 Motor del Ventilador 610190 Cronometro 611245 Interruptor con botón (1)
  • Page 15 ASSOCIATED EQUIPMENT CORPORATION 5043 FARLIN AVENUE ST. LOUIS, MO 63115 TEL. (314)385-5178 FAX. (314)385-3254 www.associatedequip.com W2539 027-0983 Rev. 20141124...

Ce manuel est également adapté pour:

Acc-6010b

Table des Matières