Operation - Labnet D1301 Mode D'emploi

5.0 Operation

1. Place Labnet Dry Bath Incubator on a sturdy and level surface in a safe, dry place, away from
laboratory traffic.
2. Ensure that the AC power switch is OFF, then plug the three-pronged power cord into a
grounded three-prong AC outlet of the appropriate voltage (115V or 220V as indicated on the
rating sticker near the AC cord on the back of the unit).
3. Select suitable module block(s) or appropriate water volume and put it / them into the Labnet Dry
Bath Incubator
4. Turn the AC power ON.
5. Run temperature calibration procedure when using the instrument for the first time.
6. Press or
7. Press or
8. Press the Key to start heating.
9. If to reset timer is required during heating, press
10. Press Key again to stop the unit.
11. If lid is to be used, aim the shaded area on the dry bath surface with the magnet of the lid and
it will be attached to the housing. In order to remove the lid, press one hand firmly on the housing
with another hand pulling the lid off. To use the lid, the tube should not be exceeding 25mm than
the heating block.
Key to adjust to the desired temperature.
Key to adjust to the desired timer.
Key to deactivate heating.
AccuBlock Digital Dry Bath | 3