Assembly - Landmann 12115 Instructions De Montage

Assembly

For proper installation, be sure to use the correct cutout
dimensions as specified for your model number. Locate your
model on the following pages for dimensions, and reference
the cut-out diagram of your unit for proper orientation.
For door
Slide the unit into the opening of the island and screw the
unit at the intended points using suitable screws (not inclu-
ded in the product scope).
Door jamb
For Drawer:
Before installing your drawer, remove the drawer from its
base by completely pulling it out. Release the drawer from
the drawer slides by pressing the black lever down on the
right side, and up on the left side. Then pull outwards on
the drawer until it comes free of the runners.
Releasing drawer from sides
1. In order to properly support the weight of your drawer,
it is necessary to provide a secure, level surface in the
rear of the cabinet (See below). Be sure that the height
of this rear support is the same height as the front ope-
ning support, so that your drawer sits level. Releasing
drawer.
Drawer
front
Side view
2. Slide the drawer into the opening of the island and use
suitable screws (not included in the product scope) to
screw the drawer in place at the intended points.
3. To reinsert the drawer, completely pull out the slide rails
and place the drawer on the rails, and then close the
drawer. Open the drawer to verify that it has locked in
place.
Drawer
support
Ardor 9