Precautions; Location Of Parts And Controls; Power Supply; Operations - Retekess TR614 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Thank you for purchasing Retekess TR614 3 band radio. Please read the manual thoroughly
before operating and keep it in a safe place for future reference.

Precautions

1. Please remove the battery when the radio is not to be used for a long time, store it
separately, and remember to charge it once a month
2. Do not use this product near water and moisture, for example: near a bathtub, washbowl,
kitchen sink or laundry tub; in a wet basement; or near a swimming pool.
3. Do not use the radio near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that produce heat.
4. Do not put the product on a bed, sofa, rug, or other similar surfaces to prevent the vents
from being blocked.
5. Do not spill or spray any type of liquid on the product. Do not allow any solid or liquid enter
the radio from the vents.
6. Do not disassemble, repair, remodel or drop the radio arbitrarily.
7. Do not expose the battery to excessive heat environments (such as direct sunlight, open
flames or similar environments)

Location of parts and controls

1. Telescopic antenna
2. Tuning Knob
3. Hand strap hole
4. Frequency indicator
5. Band Selection
6. FM Indicator
7. MW Indicator
TUNE
FM
MW
SW
FM/MW/SW 3 BAND RADIO TR614
8. SW Indicator
9. Volume/Power on/off Button
10. Headphone Jack
11. DC 5V Power Port
12. Charging Indicator
13. Battery Compartment
1

Power Supply

Operating on battery: Slide and open the battery compartment lid (13). Insert the battery with
correct polarity in the battery compartment. Close the battery compartment lid.
Charging: You need to charge the battery when the radio is in low batter. Using the USB
cable that included in the package, connect the AC power adaptor securely to the DC 5V jack
to start charging, the Charging Indicator (12) in Red color while charging, and it turn green
after the battery is fully charged.
NOTE:
1. Improper replacement of the battery will cause explosion hazard. Only the same type or
equivalent type can be used.
2. Do not bend or twist the power cord forcibly. Do not place heavy objects on the power cord.
3. Always hold the plug when disconnecting the power cord. Do not pull the cord itself.
4. Disconnect the AC power adaptor from the wall outlet and radio when the unit is not to be
used for a long period of time.

Operations

1. Slide the Power on/off button (9) to ON position to turn on the radio
2. Slide the Band button (5) to FM, MW or SW band position as desire
3. Tuning the Tuning knob (2) to select desired station.
4. Slide the Volume Control Knob (9)to adjust volume level as desired.
To improve reception
FM reception: Extend the telescopic antenna (1), and adjust the direction and angle.
MW reception: Retract the telescopic antenna and rotate the unit to reorient the built-in
ferrite bar antenna
SW reception: Fully extend the telescopic antenna vertically.
For SW reception, you can enjoy even better reception by using an external
antenna

Specifications

Power input: 5V
0.6A
Rated power: 3W
Lithium battery: 3.7V
Frequencies: FM: 88-108MH
MW: 530-1600KHz
SW: 8.0-18.0MHz
Antenna: FM/SW: telescopic antenna
MW: built-in ferrite bar antenna
Speaker: 100mm, 6Ω
The maximum power without distortion: 1W
Maximum power consumption: 3W
Size: 202 x 125 x 50mm
Weight: 375.8g (without battery)
Include accessories: User manual, Rechargeable lithium battery, USB cable, Hand strap.
2

Publicité

Table des Matières
loading

Table des Matières