Die Selection - Panduit CT-2930/L Mode D'emploi

An incomplete crimp can cause a fire.
Use proper connector and cable combinations. Improper combinations can result in an incomplete crimp.
The relief valve will sound to indicate a completed crimp. If you do not hear the sound of the relief valve, the crimp is not
complete.
Inspect tool before use. A worn or damaged tool may result in breakage striking the operator or nearby personnel.
Do not perform any service or maintenance other than as described in this manual.
Injury or damage to the tool may result.
Do not operate the tool without dies. Damage to the ram or crimping tool head can result.
This tool is not designed for continuous use.
After 30 to 40 cycles, allow the tool to cool for 15 minutes.
Do not place the tool in a vise. The tool is designed for hand-held operation.
Protect the tool from rain and moisture. Water will damage the tool and battery.
Electric-hydraulic tools should not be operated in pouring rain or under water.
Use this tool for the manufacturer's intended purpose only.
Keep the tool head and tool body portion clean and free from debris. Soap and a damp cloth should be used to clean the
tool body.
Always store the tool in its clean, dry carrying case when not in use.
DO NOT press trigger and release button simultaneously. Damage to trigger linkage may result.
DO NOT let the ram contact the crimp head.
Always point tool away from others.
If the tool is kept in cold temperatures below 23
temperature for 1 hour before using.
Always verify the proper size connector for the conductor, by checking the color code and the printing on the connector.
Avoid dropping the tool. Extreme shock may damage the hydraulic circuit and result in malfunction of the tool.
NOTE: CONNECTIONS UTILIZING THIS TOOL ARE U.L. LISTED AND C.S.A. CERTIFIED ONLY WHEN
PANDUIT COMPRESSION CONNECTORS ARE USED. USE OF ANY OTHER BRAND OF
COMPRESSION CONNECTORS IS NOT RECOMMENDED.

DIE SELECTION

NOTE: DIES ARE DESIGNED TO PROVIDE THE
HIGHEST QUALITY CRIMPING WHEN USED WITH
PANDUIT COMPRESSION CONNECTORS.
USE OF ANY OTHER BRAND OF CONNECTORS IS
NOT RECOMMENDED WITH CD-920 or CD-930 DIES.
MAINTENANCE
It is recommended that the hydraulic fluid be changed every 24 months. The tool should be returned to
Panduit Tool Solutions Division (USA); or Panduit EMEA (EUR) for proper oil changing.
CT-2930/L & CT-2930/LE_ENGL: PA26009A01_02
CT-2930/L and CT-2930/LE ENGLISH
WARNING
CAUTION
IMPORTANT INFORMATION
o o
F/-5 C for any extended time, it is advisable to return the tool to room
Page: 4 of 48 6-2012