Ebode LightSpeaker State-of-the-Art Wireless SubWoofer Guide Utilisateur page 13

A) As in the case with the phase switch this step is easier to
perform with two people. Sit or stand in your preferred listening
position while another person pushes the button immediately
below the LEDs that mark the three different crossover
frequencies. Each time the button is pushed the crossover will
cycle to the next frequency first 80Hz (LED will light up), then
100Hz, and finally 120Hz. The next push of the button will light
the 80Hz frequency again.
B) Choose the setting that sounds the best and leave the
crossover set to this frequency. This can be changed at any
time in the future and will not affect the operation of either your
SubWoofer or your LightSpeaker system.
Step 7: Setting the volume control.
Your ebode Wireless SubWoofer has a built in volume control
so it can be matched to different numbers of LightSpeakers.
The more LightSpeakers in the listening area, the higher the
volume should be set.
Low Pass Crossover
80 Hz 100 Hz 120 Hz
+
+
Phase Zone
+ +
0° 180° 1 2
+
Volume
Status
+
Pairing
13