Publicité
Les langues disponibles
Les langues disponibles
6
Load configuration
1. Select the item «Files» in the left menu bar and click on «Select file».
Now select the RSC file that you downloaded in step 2.
2. Now click on «System» in the left menu bar and then on «Reset
Configuration».
7
Instruction | Fiber7-X, Fiber7-X2 | MikroTik
3. Check the boxes as shown in the illustration and select the file
downloaded in step 2 under «Run After Reset».
4. Click on «Reset Configuration». The router will now restart. After the
restart, the default settings will be reloaded.
5. Do not forget to change the IP settings back to «automatic» (DHCP)
(remove manual IP configuration from step 3.)
Troubleshooting: connection fails
If the connection with the router fails, you can reset the device to the
factory settings.
1. Disconnect the router from the power source.
3. Take a paper clip and press the reset button on the front. Press and
hold the reset button.
4. Reconnect the router to the power. The LED will light up and start flashing
after about 8 seconds. As soon as the LED starts flashing, release the reset
button. Now repeat step 2 (assign static IP address).
06 | 2022 | Nr. 02
EN
EN
8
Publicité
