sunjoe 24V-X2-DTS15 Manuel D'utilisation page 11

4. When the charger lights turn green, the batteries are fully
charged (Fig. 3).
NOTE: A fully discharged pack with an internal
temperature in the normal range will fully charge in
1 hr 50 min (between 32ºF/0ºC and 113ºF/45ºC).
5. If the light indicators do not come on at all, check that
the battery packs are fully seated into the bay. Remove
the battery packs and reinsert. If the problem persists,
contact an authorized Snow Joe
call the Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563) for assistance.
6. When charging is complete, remove the batteries from the
charger by pressing the push lock buttons and sliding the
batteries backward to unlock them from the charger
(Fig. 4).
Fig. 4
m
CAUTION!
FIRE HAZARD. When removing the batteries
from the charger, be sure to unplug the charger from the outlet
first, then remove the batteries from the charger.
m
WARNING!
This charger does not automatically turn
off when the batteries are fully charged. Please take care not
to leave the batteries in the charger. Switch off or unplug the
charger at the mains when charging is complete.
7. Timely recharging of the batteries will help prolong the
batteries' life. You must recharge the battery packs when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery packs to become
fully discharged as this will cause irreversible damage to the
batteries.
+ Sun Joe dealer or
® ®
customer service center at
®
Push lock
button
Charging a Hot or Cold Battery Pack
The green indicator lights on the charger base indicates that
the battery packs' temperatures are outside the charging
range. Once the packs are within the acceptable range,
normal charging will take place and the red light will be
continuous. Hot or cold battery packs may take longer to
charge.
Lithium-Ion Charging Status
Charger
Battery
Base
Pack
Indicator
Temperature
Light
Too hot
Green
Normal range
Too cold
Green
Assembly
m
WARNING!
Do not insert the batteries until assembly is
complete. Failure to comply could result in accidental starting
and severe personal injury.
Always wear gloves during assembly.
Connecting the Handle
1. Fit the upper handle frame on the lower handle bars, and
secure with 2 sets of handle knob and bolt (Fig. 5).
Fig. 5
Handle knob
Bolt
2. Clip the cable clips on the handle, and Insert the cable in
the cable clips.
11
Battery
Pack Charging
Indicator
Light
Flashing
Not charging
together
Flashing
Red
one by one
Flashing
Not charging
together
Upper handle
frame
Lower handle
bars
R
Status
Normal
charging