AUTO-HAK F26A Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
16
12
7
9
16
9
5
8
This towbar is designed to assembly in following cars:
Peugeot 807, Fiat Ulysse, Citroen C8, Lancia Z (all 5 doors and VAN)
produced since 2002 cat. no. F26A and is prepared to tow trailers max total
weight 1850 kg and max vertical load 76 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
The instruction of the assembly
1. Disassemble the rear bumper .
2. Mounting points are original points described by a car producer. This places
are covered by sticker, take them out.
3. To uncovered holes put special nuts „Caget nut" (pos.7).
7
9
7
9
6
19
20
3
7
1
23
From manufacturer
4. Put mian bar of the towbar in this way, so towbar's holes agree with caget nut,
fix by M10x35mm bolts (pos. 9) as shown on the drawing (loosely).
5. Fix side brackets pos. 4, 5 and flat bar pos. 6 .
6. Cut the bumper according to the fig. 2 and then reassemble it.
4
9
8
21
7. Fix body of the automat (pos. 23) using bolts M12x25mm (pos. 7) from
accessories. Place tow-ball (pos. 2) according to supplied instruction.
Fix tow-ball (pos. 2) using bolts M12x75mm (pos. 7) from accessories.
2
8. Fix the socket plate (pos. 3) as shown on the drawing.
9. Tighten all bolts according to the torque shown in the table.
10. Connect electric wires of 7-poles socket according to the instruction of the car.
(Recommend to make at authorized service station)
11. Complete paint layer damaged during installation.
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
•
Indicators
•
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
80
45
Fig. 2
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
65
M10 - 50 Nm
M16 - 210 Nm