General Maintenance; Power Supply - Philips SA107 Mode D'emploi

XP SA 107/17 11-07-2000 11:11 Pagina 8

GENERAL MAINTENANCE

• To avoid damage or malfunction:
– Do not expose the set, batteries, or SmartMedia cards to
strong magnetic fields, humidity, rain, sand, or excessive
heat caused by heating equipment or direct sunlight.
– Do not drop the set or allow objects to fall on the set.
• Do not allow the set to contact water. Wipe the surface of
the set dry if wet. Water entering the set may cause major
damage.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene, or abrasives as these may harm the set.
8

POWER SUPPLY

BATTERIES
1 Open the battery compartment and insert two batteries
(preferably alkaline) type AAA as indicated by the + and –
symbols inside the battery compartment.
2 Close the battery compartment door.
™
appears on the display.
INDICATION OF EMPTY BATTERIES
The number of blocks inside the battery symbol
the power level.
• When the power level is almost empty, the symbol
to flash. Replace the batteries or change to AC power.
• appears on the display if you ignore the flashing.
The set will switch off automatically.
Important!
• Remove the batteries if they are dead or if the set is not to
be used for more than two weeks.
• Batteries contain chemical substances, so they should be
disposed of properly.
• This set does not have an on board function for
rechargeable batteries.
indicates
starts