AGA MARVEL 30ARM Instructions D'installation, D'utilisation Et D'entretien page 14

is attached to the door and cabinet. After the panel is removed
from the door, drill the mounting holes from the front, to the
recommended diameter of the handle manufacturer. Counter
bore the back-side of the panel so the screw heads do not inter-
fere with the surface of the door.
Step 6: Drill panel mounting holes
Re-clamp the panel to the door per step 5 and drill the screw
pilot holes for attaching the overlay panel to the door. Select
the size of the hole from Table B. Be careful not to drill the pilot
holes through the overlay panel, (1/2" (12.7mm) deep for 3/4"
(19mm) and 5/8" (15.7mm) panels ).
Material Type
Hardwood 1/8" (3.2mm) Diameter. Pilot Hole
Softwood 7/64 (2.8mm) Diameter. Pilot Hole
NOTE
If your refrigerator has a door lock proceed to Step 7. If your
refrigerator does not have a door lock proceed to Step 9.
Step 7: Mark and drill lock hole.
Locate and mark with a pencil the location of the lock hole
on the overlay panel, this is the hole in the top corner of the
handle side of the door. Remove the clamp and remove the
overlay panel from the door. On the backside of the panel
where you marked the lock location drill a 13/16" (20.5mm)
diameter counter bore 7/16" (11.0mm) deep into the overlay
panel. Drill a 15/32" (12.0mm) diameter hole through the
overlay panel centered on the counter bore being careful not
to splinter the wood on the face side of the panel.
(See Figure 11).
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
#8 Wood Screw
Table B
1.234" (31.3mm)
.991" (25.2mm)
Figure 9
Figure 10
14
Top Hinge
Adapter
Hole in hinge
adapter
Door
Overlay Panel
Hole in bottom
hinge adapter